CP Seal Height Rod slide" This is one of the

This is one of the most commonly used sensors on all Evolution Series

The Can a Index Exit Sensors are used on Wild Goose Filling WG8/10 canning lines only and are used to detect the presence of cans as they exit the seamer

This sensor cable supplies power to the Lid Present in Chute Sensor and sends a signal back to the machine's PLC

This part houses the internal bearings and bearing spacer for the Spindle Pack Assembly

number of pins/wires: 3

CP Seal Height Rod slide" This is one of theThe CP Seal Height Rod (AKA Tapped Linear Motion Shaft) is used on all Fusion Counter Pressure systems and is used to guide the Fill Head Raise Plate as it moves up and down. All are turned, ground, and polished to tight diameter and straightness tolerances. The surface is hardened, so they stand up to repeated motion while keeping their center soft enough to absorb stress from shifting loads. Chamfered edges remove sharp corners at the end of these